Valentine's Day cu ZW3D
Nu este nici un secret ca trandafirul este cea mai oferita floare de Valentine's Day.
Lasand la o parte semnificatiile castigate de-a lungul timpului, trandafirul exprima dragoste, romantism, finete, ceea ce il face ideal pentru a fi oferit in aceasta zi de Februarie. Asadar astazi, iti vom arata cum sa "proiectezi" un trandafir cu ZW3D 2019. Urmareste filmuletul si fa speciala aceasta zi si prin placerea de a crea ceva unic si special.
Vei intelege ca ZW3D este o unealta pe care trebuie sa o ai atunci cand vrei sa exprimi.
Vrei sa testezi ZW3D 2019?
Trandafirul
Sa trecem la treaba!
Pasul 1 - Curbele de contur principale ale trandafirului
Draw the main contour curves of the rose on the XZ plane. Curve 1 will make up the bud, Curve 2 to 4 will make up the petals, Curve 5 the receptacle, and Curve 6 the stem. It should be noted that the starting and ending points of Curve 1 should be in one vertical line.
Pasul 2 - Extrage curbele din schita
Use the Curve List command to detach the contour curves from the sketch.
Pasul 3 - Genereaza bulbul si petalele
Use Revolve command to draw the bud, petals, and receptacles. Select Curves 1 to 5 respectively, revolve around the Z-axis (360° for Curve 1 and Curve 5, -55° and 55° for Curve 2 and 4, -110° and 0° for Curve 3) to generate the bud, three petals, and a receptacle.
Pasul 4 - Deseneaza doua curbe
Since the edge of the rose is too sharp, we need to trim it. Use Through Point Curve command to draw two curves.
Pasul 5 - Taie colturile petalei
Use Trim to Curves command to trim the petal, to make it more natural.
Pasul 6 - Da o grosime petalei
Thicken the petal to change it from a surface to a solid. Now, a petal was born.
Pasul 7 - Multiplica petalele create
Use the same method to generate the other two petals. Then pattern these three petals at 120° around the Z-axis by Pattern Geometry function.
Pasul 8 - Finalizeaza baza florii
Thicken the receptacle. Then the main part of the rose is completed.
Pasul 9 - Deseneaza un cerc
Create a datum at the endpoint of Curve 6 and draw a circle around it.
Pasul 10 - Creaza tulpina
Use Sweep command and set the scale of transform as below to create a stem for the rose.
Pasul 11 - Extrudeaza pentru a obtine doua suprafete
Draw two curves on a sketch, then extrude them by the Extrude command to create two surfaces.
Pasul 12 - Decupeaza frunzele
Repeat Step 4 to 6 to beautify the leaves
Pasul 13 - Produs final
Render with Keyshot, then a charming rose is finally ready for your significant other! What if he or she doesn’t like roses? Follow the above steps, and you can also design your own ones easily with ZW3D’s amazing Hybrid Modelling technology.